Cell Spy

 

 

 

 

 

 

 

 

 

 

 

 

Cell Spy lipo voltage tester 

#SPY-1 $12.99 

                                                                                                        $12.99

 

The Cell Spy makes checking the voltage of your lipo packs easier than ever. It provides a digital read-out that can show up to 3 cell voltages in rotation. With 2.5mm pin spacing, it works with 95% of the lipos on the market. 

 

Cell spy instructions Thanks for purchasing a commonsense RC sell spy -- the most convenient way to check the balance and voltage of your two and three cell Lipo packs. (Larger packs can be checked as well). 

 

This unit will read back the individual voltages of the cells in your Lipo pack it has 2.5 mm pin spacing, which is used by almost all Lipo manufacturers. If your battery pack has 2 mm spacing (used by thunder power and CellPro), you will need to use our part # TP2UB adapter to convert the spacing to 2.5 mm. 

 

To use your cell spy with 2-3 cell Lipo packs, simply plug it into the balancer connector of your battery pack, being sure to connect the negative port on your balance connector to the pin of the cell spy. The negative pin of the cell spy is the pin closest to the center of the circuit board. 

The unit will power up and begin displaying voltages from your pack. Allow about 6 seconds for the voltage reading to stabilize when you connect to a pack. The LED display will flash twice to indicate that it is ready to read

 

The display works a bit differently from how you might expect. The dot in the bottom of the display is not the decimal point. It indicates which cell is being read. As it moves from right to left, it progressively indicates cell 1, cell 2, and cell 3. The display is accurate to 0.01V, so if it is displaying 413, then the cell it is testing is at 4.13 V. 

To test packs with more than three cells, simply start at the negative port on the balance plug, and once you have checked the first three cells with ports 1-4, move the checker up the balance plug so that pin one on the checker is plugged in to port 4 on the balance plug. Repeat as necessary, moving the checker three pins up each time.

 

When you're done checking voltages, be sure to disconnect the cell spy to prevent it from slowly discharging your packs. 

 

To Order:  You can order by contacting us through email or phone. Payment will be set up through paypal, credit cards or check.

 

Roy Seals/H.P.Pilots

6942 Audrain Road 9137

Centralia, MO 65240 

 

573-682-2333 

Cell 920-344-8866 

Cell 920-344-0266 

royseals@wi.net 

 

H.P.Pilots © 12/1/2000 -2007

 

 

© 2000 H.P.Pilots - 2007

 

H.P.Pilots   Don't Trust Your Plane To Just Any Pilot!